First of all, when you create a
flag case, you have to use glass as a cover.
You can accurate get the right measurements of the glass in two methods:
1. Get the right size then reduce by 1/8 of an inch.
2. Measure the glass by an extra 1/4 inch to properly fit it into the frame.
Acquire a wooden corner board measuring 8 feet.
For the outer corners of the walls, the wood should be 3/4 inch on each side of the 45-degree angle.
Cut properly so that the outer part of the triangle frame properly houses the wood.
The glass can then be positioned from the rear part after the corner of the outer wood has been nailed.
Next, cut and put three pieces of molding measuring 1/4 x 1/4 inch from the inner portion to put the glass.
A table saw will be required for the inset glass.
Prepare the table saw guide from the inner part of the saw blade by 1/4 inch to keep the cut accurate.
Prepare the blade depth to 1/8 inch.
From the beginning, you have to be informed about the glass to be inset. Cut the full 8-foot board in a single session. You will find it rather challenging to cut several small pieces and get the right measurements.
If you’re not familiar with a table saw, it’s best to get a professional to make the cuts. Get the right pieces but properly using the table saw.
Labels: custom flag, custom flag maker, custom flag. personalized flag, flag cases
by:
The Flagman
